LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Crankcase Ventilation Hoses/Pipes Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
    IMPORTANT: After removing the charged air cooler duct, cover the turbocharger opening with tape in order to prevent entry of objects.
  2. Loosen the charged air cooler inlet duct connector to turbocharger clamp (1).
    3. IMPORTANT: Do not use a screwdriver or other tool to pry the hose loose. The hose can be torn or damaged. Loosen the hose by twisting.
    Fig 1: View Of Turbocharger Clamp & Charged Air Cooler Inlet Duct Connector
    GM1334380Courtesy of GENERAL MOTORS CORP.
  3. Remove the charged air cooler inlet duct connector (4) from the turbocharger.
  4. Using a pick or a small flat-bladed screw driver, remove and discard the quick connect fitting clip from the charged air cooler outlet duct.
  5. Remove the charged air cooler outlet duct from the intake.
    Fig 2: Charged Air Cooler Outlet Duct
    GM1653035Courtesy of GENERAL MOTORS CORP.
  6. Reposition the positive crankcase ventilation (PCV) hose clamp.
  7. Remove the PCV hose from the air inlet pipe.
    Fig 3: View Of PCV Hose Clamp
    GM1335454Courtesy of GENERAL MOTORS CORP.
  8. Remove the PCV hose from the clip on the top of the turbocharger.
  9. Remove the left PCV hose/pipe bolt.
    Fig 4: View Of Left PCV Hose/Pipe Bolt
    GM1335460Courtesy of GENERAL MOTORS CORP.
  10. Remove the right PCV hose/pipe bolt.
    Fig 5: View Of Right PCV Hose/Pipe Bolt
    GM1335456Courtesy of GENERAL MOTORS CORP.
  11. Remove the PCV hose/pipe.
scientia non olet · About LEMON Manuals