Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the PCV hose/pipe.
NOTE: Refer to Fastener Notice .
Install the right PCV hose/pipe bolt.

Fig 1: View Of Right PCV Hose/Pipe Bolt
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the bolt to 18 N.m (13 lb ft).
Install the left PCV hose/pipe bolt.

Fig 2: View Of Left PCV Hose/Pipe Bolt
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the bolt to 18 N.m (13 lb ft).
Install the PCV hose to the air inlet pipe.

Fig 3: View Of PCV Hose Clamp
Courtesy of GENERAL MOTORS CORP.
Position the PCV hose clamp.
Install the PCV hose to the clip on the top of the turbocharger.
Install a NEW quick connect fitting clip to the charged air cooler duct.
Install the charged air cooler outlet duct to the intake.

Fig 4: Charged Air Cooler Outlet Duct
Courtesy of GENERAL MOTORS CORP.
Remove the tape from the turbocharger openings.
IMPORTANT: Lubricate the end of the duct prior to installation.
Install the charged air cooler inlet duct connector (4) to the turbocharger.

Fig 5: View Of Turbocharger Clamp & Charged Air Cooler Inlet Duct Connector
Courtesy of GENERAL MOTORS CORP.
Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).
Tighten: Tighten the clamp to 6 N.m (53 lb in).
Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .