Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the charged air cooler.

Fig 1: View Of Charged Air Cooler & Bolts
Courtesy of GENERAL MOTORS CORP.
1. Angle in the left side.
2. Slide to the left.
3. Move in the right side.
4. Position bottom insulators in the radiator support.
  NOTE: Refer to Fastener Notice .
Install the charged air cooler bolts.
Tighten: Tighten the bolts to 21 N.m (15 lb ft).
Install the radiator. Refer to Radiator Replacement (Diesel) .
Install the charged air cooler hoses/pipes. Refer to Charged Air Cooler Hoses/Pipes Replacement (Left) or Charged Air Cooler Hoses/Pipes Replacement (Right) .