LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Camshaft Reluctor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the camshaft reluctor to the camshaft gear.
    Fig 1: View Of Camshaft Reluctor & Bolts
    GM739316Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the camshaft reluctor bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    3. IMPORTANT: Do not damage the teeth on the reluctor.
    Fig 2: View Of Oil Pump Drive Gear
    GM738904Courtesy of GENERAL MOTORS CORP.
  3. Install the oil pump drive gear and reluctor to the crankshaft.
  4. Install the oil pump driven gear.
    Fig 3: View Of Oil Pump Driven Gear & Nut
    GM738905Courtesy of GENERAL MOTORS CORP.
    5. NOTE: Do not use an impact driver to remove or install the oil pump driven gear nut. Use of an impact driver may shear the oil pump drive gear pin in the crankshaft.
  5. While holding the secondary oil pump shaft with a hex driver, install the oil pump driven gear nut.

    Tighten:  Tighten the nut to 100 N.m (74 lb ft).

  6. Install the upper oil pan. Refer to Oil Pan Replacement - Upper .
  7. Install the engine front cover. Refer to Engine Front Cover Replacement .
scientia non olet · About LEMON Manuals