LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Pump Locator Pins
    GM869741Courtesy of GENERAL MOTORS CORP.
  1. Inspect for properly installed oil pump locator pins.
    2. Fig 2: Oil Pump & Mounting Bolt
    GM869740Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the oil pump driveshaft retainer. During assembly, install a NEW oil pump driveshaft retainer.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the oil pump. Position the oil pump onto the locator pins.
  3. Install the oil pump bolt.

    Tighten:  Tighten the bolt to 90 N.m (66 lb ft).

  4. Install the oil pan. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals