Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Right Engine Mount Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the engine mount bracket.
Perform the following procedure prior to installing the engine mount bracket bolts.
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the engine mount bracket bolts.
Tighten: Tighten the engine mount bracket bolts to 75 N.m (55 lb ft).

Fig 2: View Of Right Side (Left Side Similar) Engine Mount Side Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

Position the engine mount side bracket to the engine, if removed.
Install the engine mount side bracket bolts.
Tighten: Tighten the engine mount side bracket bolts to 50 N.m (37 lb ft).

Fig 3: View Of Right Side (Left Side Similar) Engine Mount Bolts

Courtesy of GENERAL MOTORS CORP.

Install the engine mount.
Install the engine mount bolts.
Tighten: Tighten the engine mount bolts to 50 N.m (37 lb ft).
Lower the engine.
Install the starter. Refer to Starter Motor Replacement (4.3L Engine) or Starter Motor Replacement (4.8L, 5.3L, and 6.0L Engines) or Starter Motor Replacement (8.1L Engine) or Starter Motor Replacement (6.6L (LLY) Engine) in Engine Electrical.

Fig 4: Identifying Oil Pan Skid Plate

Courtesy of GENERAL MOTORS CORP.

Install the oil pan skid plate and bolts.
Tighten: Tighten the oil pan skid plate bolts to 20 N.m (15 lb ft).
Lower the vehicle.

Fig 5: View Of Right Side (Left Side Similar) Engine Mount To Engine Mount Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the engine mount to engine mount bracket bolts.
Tighten: Tighten the engine mount to engine mount bracket bolts to 65 N.m (48 lb ft).