LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: Refer to ENGINE MOUNTING NOTICE in Cautions and Notices.
    Fig 1: View Of Right Side (Left Side Similar) Engine Mount To Engine Mount Bracket Bolts
    GM310259Courtesy of GENERAL MOTORS CORP.
  1. From under the hood, remove the engine mount to engine mount bracket bolts. (right side shown, left side similar).
    2. Fig 2: Identifying Oil Pan Skid Plate
    GM309158Courtesy of GENERAL MOTORS CORP.
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the oil pan skid plate bolts and plate.
    4. NOTE: Refer to ENGINE LIFTING NOTICE in Cautions and Notices.
    Fig 3: View Of Square Tab At Rear Of Engine Block
    GM374320Courtesy of GENERAL MOTORS CORP.
  4. Using an adjustable jack on the square tab at the rear of the engine block, raise the engine.
    5. Fig 4: View Of Right Side (Left Side Similar) Engine Mount Bolts
    GM310267Courtesy of GENERAL MOTORS CORP.
  5. Remove the engine mount bolts. (right side shown, left side similar).
  6. Remove the engine mount.
    7. Fig 5: View Of Right Side (Left Side Similar) Engine Mount Side Bracket & Bolts
    GM310262Courtesy of GENERAL MOTORS CORP.
  7. If equipped and necessary, remove the engine mount side bracket bolts and bracket. (right side shown, left side similar).
    8. Fig 6: View Of Left Engine Mount Bracket Bolts
    GM781984Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine mount bracket bolts.
  9. Remove the engine mount bracket.
scientia non olet · About LEMON Manuals