LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement - without Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Idler Pulley (W/O AC)
    GM781982Courtesy of GENERAL MOTORS CORP.
  1. Install the idler pulley.
  2. Install the idler pulley bolt until snug.
  3. Install the drive belt. Refer to Drive Belt Replacement .
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals