LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Right Idler Pulley
    GM781979Courtesy of GENERAL MOTORS CORP.
  1. Install the idler pulley.
  2. Install the idler pulley bolt until snug.
  3. Install the drive belt. Refer to Drive Belt Replacement .
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals