LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Crankshaft Rear Oil Seal Notches
    GM31379Courtesy of GENERAL MOTORS CORP.
  1. Remove the flywheel. Refer to Engine Flywheel Replacement .
  2. Insert a flat-tipped screwdriver into the access notches and carefully pry the seal from the housing.
  3. Discard the seal.
  4. Clean off any dirt or rust in the area.
scientia non olet · About LEMON Manuals