LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Do not remove the crankshaft rear oil seal housing if only replacing the crankshaft rear oil seal.
    Fig 1: Crankshaft Rear Oil Seal Housing & Bolts
    GM524317Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil pan. Refer to Oil Pan Replacement .
  2. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
  3. Remove the housing bolts and nut.
  4. Remove the housing.
    5. Fig 2: Locating Crankshaft Rear Oil Seal Housing Gasket
    GM524322Courtesy of GENERAL MOTORS CORP.
  5. Remove and discard the housing gasket.
  6. Clean all the sealing surfaces.
  7. Inspect and replace the housing for warping, cracks, wear, or damage.
scientia non olet · About LEMON Manuals