LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 4.3L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm Cover Installation - Right

Valve Rocker Arm Cover Installation - Right

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Rocker Arm Cover And Gasket
    GM328573Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the valve cover gasket or the valve rocker arm cover bolt grommets.
  1. Install the NEW valve rocker arm cover gasket into the groove of the valve rocker arm cover.
  2. Install the NEW valve rocker arm cover bolt grommets into the valve rocker arm cover.
    3. Fig 2: View Of Valve Rocker Arm Cover (Right)
    GM480524Courtesy of GENERAL MOTORS CORP.
  3. Install the valve rocker arm cover onto the cylinder head.
    4. Fig 3: Valve Rocker Arm Cover Bolts (Right)
    GM328568Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the valve rocker arm cover bolts.

    Tighten:  Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

scientia non olet · About LEMON Manuals