Tools Required

J 23523-F  Balancer Remover and Installer

Fig 1: View Of Crankshaft Balancer Washer & Bolt
Courtesy of GENERAL MOTORS CORP.
1. Remove the crankshaft balancer bolt and washer.
Fig 2: View Of Crankshaft Pulley & Bolts
Courtesy of GENERAL MOTORS CORP.
2. Remove the bolts and the crankshaft pulley.
Fig 3: Removing Crankshaft Balancer Using J 23523-F
Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Use the J 23523-F  in order to remove the crankshaft balancer.
   1. Install the J 23523-F  plate and bolts onto the crankshaft balancer.

      Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

   2. Install the J 23523-F  forcing screw into the plate.
   3. Rotate the J 23523-F  forcing screw clockwise in order to remove the crankshaft balancer.
4. Remove the J 23523-F  from the crankshaft balancer.
Fig 4: View Of Crankshaft Balancer Weights
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: If replacing the crankshaft balancer, NEW weights must be installed into the NEW crankshaft balancer, in the same location as the old weights in the old balancer.
5. Note the position and length of any crankshaft balancer front groove pins, if applicable.