Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
- The PCM detects that the HO2S bank 1 sensor 2 or HO2S bank 2 sensor 2 did not transition below 349 mV and above 710 mV during the passive test.
- One of the following tests fail:
- Lean Intrusive Test
- The PCM detects that the HO2S bank 1 sensor 2 or HO2S bank 2 sensor 2 is more than 349 mV for 60 seconds.
- The HO2S bank 1 sensor 1 and HO2S bank 2 sensor 1 is less than 300 mV.
OR
- Rich Intrusive Test
- The PCM detects that the HO2S bank 1 sensor 2 or HO2S bank 2 sensor 2 is less than 710 mV for 60 seconds.
- The HO2S bank 1 sensor 1 and HO2S bank 2 sensor 1 is more than 600 mV.
- Lean Intrusive Test