Countershaft Disassemble

Tools Required 

J 44749  Split Plate Bearing/Gear Puller

IMPORTANT:
• Only remove the bearings if replacing the bearings. Do not use the bearings again after removal.
• You must also replace the race for the bearing being replaced.
1. Inspect the bearings for damage or wear. Refer to Bearings and Spacers Cleaning and Inspection .
2. Using a hydraulic press and the J 44749  (1), remove the countershaft intermediate case bearing. Use the flat side of the J 44749  against the bearing.
   Fig 1: Removing Countershaft Intermediate Case Bearing

   Courtesy of GENERAL MOTORS CORP.
3. Using a hydraulic press and the J 44749  (1), remove the bearing from the front of the countershaft.
   Fig 2: Locating Bearing Assembly

   Courtesy of GENERAL MOTORS CORP.