Installation Procedure

WARNING: This page is about a different variant/trim than selected.

If equipped with a RPO ML6 manual transmission, install the TAC module bracket, if necessary.
NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: TAC Module Bracket - RPO ML6 Manual Transmission
Courtesy of GENERAL MOTORS CORP.
Install the TAC module bracket nuts.
Tighten: Tighten the nuts to 9 N.m (80 lb in).
If equipped with a RPO ML6 manual transmission, snap the TAC module to the bracket.

Fig 2: TAC Module And Bracket - RPO ML6 Manual Transmission
Courtesy of GENERAL MOTORS CORP.
Install the TAC module.
Install the TAC module nuts.

Fig 3: Throttle Actuator Control (TAC) Module Nuts
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the nuts to 9 N.m (80 lb in).
Connect the engine wiring harness electrical connector (1).

Fig 4: View Of TAC Module Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Connect the I/P harness electrical connector (2).

Fig 5: I/P Wiring Harness Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install the CPA retainer (1).