LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Lubricate the port of the MAP sensor with clean engine oil. Avoid dipping the sensor port directly into the lubricant or using a solid type of lubricant, as they may block the vacuum port signal.
  1. Install the MAP sensor.
    Fig 1: MAP Sensor And Mounting Bolt
    GM858207Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the MAP sensor bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  3. Connect the MAP sensor electrical connector (1).
    Fig 2: View Of Ignition Coil, ECT And MAP Sensor Electrical Connectors
    GM750529Courtesy of GENERAL MOTORS CORP.
  4. Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
scientia non olet · About LEMON Manuals