LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the bleed hose on the J 34730-1A  from the approved container.
    Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
  2. Remove the shop towel from around the fitting and discard into an approved container.
  3. Disconnect the J 34730-1A  from the fuel pressure valve.
  4. Install the fuel rail pressure fitting cap.
  5. Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
scientia non olet · About LEMON Manuals