LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement (Cab/Chassis - Rear) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the fuel fill and vent hoses to the tank.
  2. Tighten the fuel vent pipe hose clamp (1) at the tank.
    Fig 1: Fuel Fill Pipe & Fuel Vent Pipe Hose Clamps
    GM1228175Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the fuel fill pipe hose clamp (2) at the tank.

    Tighten:  Tighten the clamps to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals