LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Connect the EVAP purge tube at the EVAP pipe.
  2. Connect the EVAP purge tube clip to the fuel rail bracket.
    Fig 1: Connecting EVAP Purge Tube To Fuel Rail Bracket
    GM843918Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP purge tube at the purge solenoid.
    Fig 2: View Of EVAP Purge Tube At Purge Solenoid
    GM843915Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel injector harness electrical connector (3).
    Fig 3: View Of Generator, Injector Harness, Ignition Coil Harness, ETC & Purge Valve Solenoid Electrical Connectors
    GM1235689Courtesy of GENERAL MOTORS CORP.
  5. Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
scientia non olet · About LEMON Manuals