Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the fuel and EVAP bundle.

Fig 1: Installing Fuel And EVAP Bundle
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the fuel and EVAP bundle nuts.
Tighten: Tighten the nuts to 12 N.m (106 lb in).
Remove the caps from the fuel and EVAP lines at the fuel tank.
Connect the fuel and EVAP quick connect fittings. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .

Fig 2: Fuel And EVAP Lines At The Fuel Tank
Courtesy of GENERAL MOTORS CORP.
If equipped with 4WD, install the fuel line clip to the bracket on the transfer case.
Install the fuel line clip(s) to the bracket(s) on the transmission.

Fig 3: Installing Fuel Line Clip To Bracket On Transmission
Courtesy of GENERAL MOTORS CORP.
Install the fuel pipe bracket to the bellhousing stud.

Fig 4: View Of Fuel Pipe Bracket & Nut At Bellhousing
Courtesy of GENERAL MOTORS CORP.
Install the fuel pipe bracket nut.
Tighten: Tighten the nut to 10 N.m (89 lb in).
Lower the vehicle.
Remove the cap from the fuel rail.
Connect the fuel feed line (1) at the engine. Refer to Quick Connect Fitting(s) Service (Metal Collar) .

Fig 5: View Of Fuel Feed Pipe & EVAP Canister Purge Pipe
Courtesy of GENERAL MOTORS CORP.
Connect the EVAP canister purge tube line (2).
Install the fuel fill cap.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
Use the following procedure in order to inspect for leaks:
1. Turn the ignition ON, with the engine OFF, for 2 seconds.
2. Turn the ignition OFF for 10 seconds.
3. Turn the ignition ON, with the engine OFF.
4. Inspect for fuel leaks.