LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister/Fuel Tank >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the caps from the fuel and EVAP lines.
  2. Install the EVAP canister purge line (2). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    Fig 1: Reconnecting EVAP Canister & Purge Lines
    GM1306357Courtesy of GENERAL MOTORS CORP.
  3. Install the EVAP canister line (1). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Install the EVAP canister. Refer to Evaporative Emission (EVAP) Canister Replacement (Pickup)  or Evaporative Emission (EVAP) Canister Replacement (Cab/Chassis) .
scientia non olet · About LEMON Manuals