LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement (Cab/Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the EVAP canister.
    Fig 1: EVAP Canister (Cab/Chassis)
    GM1228177Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP canister nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  3. Connect the canister EVAP line to the fuel bundle line.
  4. Connect the fuel tank EVAP line to the canister.
  5. Connect the EVAP CVS line to the canister.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals