LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the engine shield bolts and shield, if equipped.
    Fig 1: View Of Engine Protection Shield
    GM349061Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the camshaft position (CMP) sensor electrical connector (1).
    Fig 2: Disconnecting CMP Sensor Electrical Connector
    GM750902Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor bolt.
  5. Remove the CMP sensor.
    Fig 3: Removing CMP Sensor
    GM858218Courtesy of GENERAL MOTORS CORP.
  6. Inspect the CMP sensor for wear, cracks or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals