Crankshaft Balancer Installation

WARNING: This page is about a different variant/trim than selected.

Tools Required

J 44643 Flywheel Hold Tool. See Special Tools .

Lightly lubricate the crankshaft balancer internal hub with engine oil.
Install the crankshaft balancer to the crankshaft.

Fig 1: View Of Crankshaft Balancer & Bolt
Courtesy of GENERAL MOTORS CORP.
Lightly lubricate the crankshaft balancer bolt with engine oil.

NOTE: Refer to FASTENER NOTICE .

Install the crankshaft balancer bolt and washer.
Tighten:
1. Tighten the bolt to 100 N.m (74 lb ft) on the first pass.
2. Tighten the bolt an additional 105 degrees.
Remove the J 44643 . See Special Tools .