Manual Range Selection
WARNING: This page is about a different variant/trim than selected.
The shift solenoids control the upshifts in the manual ranges.
Perform the following tests, using 10-15 percent throttle angle.
REVERSE
- With the vehicle stopped, move the shift selector to REVERSE.
- Slowly accelerate the vehicle.
- Verify that there is no noticeable slip, noise or vibration.
Manual FIRST
- With the vehicle stopped, move the shift selector to FIRST.
- Accelerate the vehicle to maximum speed.
- Verify the following conditions:
- No upshifts occur.
- The TCC does not apply.
- There is no noticeable slip, noise, or vibration.
Manual SECOND
- With the vehicle stopped, move the shift selector to SECOND.
- Accelerate the vehicle to maximum speed.
- Verify the following conditions:
- The 1-2 shift occurs.
- The 2-3 shift does not occur.
- There is no noticeable slip, noise, or vibration.
Manual THIRD
- With the vehicle stopped, move the shift selector to THIRD.
- Accelerate the vehicle to maximum speed.
- Verify the following conditions:
- The 1-2 shift occurs.
- The 2-3 shift occurs.
- There is no noticeable slip, noise, or vibration.