LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  2. Disconnect the throttle position (TP) sensor electrical connector (1).
    Fig 1: View Of TP Sensor, IAC Motor, ECT Sensor, Control Port Injector Module & Engine Harness Clip Bolt
    GM782174Courtesy of GENERAL MOTORS CORP.
  3. Remove the TP sensor screws.
    Fig 2: Removing TP Sensor Screws
    GM10935Courtesy of GENERAL MOTORS CORP.
    4. NOTE: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent, as damage may result.
    Fig 3: Removing TP Sensor
    GM10936Courtesy of GENERAL MOTORS CORP.
  4. Remove the TP sensor.
scientia non olet · About LEMON Manuals