LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the TP sensor.
    Fig 1: Installing TP Sensor
    GM10936Courtesy of GENERAL MOTORS CORP.

    Align the TP sensor with the throttle shaft.

    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 2: Installing TP Sensor Screws
    GM10935Courtesy of GENERAL MOTORS CORP.
  2. Install the TP sensor screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Connect the TP sensor electrical connector (1).
    Fig 3: View Of TP Sensor, IAC Motor, ECT Sensor, Control Port Injector Module & Engine Harness Clip Bolt
    GM782174Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals