Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install a NEW throttle body seal and the throttle body.

Fig 1: View Of Throttle Body & Gasket
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Fig 2: View Of Throttle Body & Attaching Studs

Courtesy of GENERAL MOTORS CORP.

Install the throttle body studs.
Tighten: Tighten the studs to 9 N.m (80 lb in).
Connect the following electrical connectors:
- TP sensor (1)
- IAC valve (2)
Fig 3: View Of TP Sensor, IAC Motor, ECT Sensor, Control Port Injector Module & Engine Harness Clip Bolt
Courtesy of GENERAL MOTORS CORP.
Position the bracket and cables.
Install the accelerator control cable bracket with the cables attached, to the throttle body.

Fig 4: View Of Accelerator Control Cable Bracket
Courtesy of GENERAL MOTORS CORP.
Install the accelerator control cable bracket nuts.
Tighten: Tighten the nuts to 10 N.m (89 lb in).
Install the accelerator control cable slug to the throttle pulley.

Fig 5: Identifying Accelerator Cable/Throttle Body Lever
Courtesy of GENERAL MOTORS CORP.
Install the accelerator control cable to the engine bracket.

Fig 6: View Of Accelerator Cable To Accelerator Control Cable Bracket
Courtesy of GENERAL MOTORS CORP.
Install the accelerator control cable to the accelerator control bracket.
Install the cruise control cable to the engine bracket.

Fig 7: Installing Cruise Control Cable To Engine Bracket
Courtesy of GENERAL MOTORS CORP.
Install the cruise control cable to the throttle pulley.
Install the air cleaner outlet resonator stud.

Fig 8: Installing Air Cleaner Outlet Resonator Stud
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the stud to 10 N.m (89 lb in).
Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .