LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Wire Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the spark plug wire from the spark plug.
    1. Twist the boot 1/2 turn before removing the boot.
    2. Pull only on the boot or use a tool designed for this purpose in order to remove the wire from the spark plug.
  2. Remove the spark plug wire from the distributor.
    1. Twist each spark plug boot 1/2 turn.
    2. Pull only on the boot or use a tool designed for this purpose in order to remove the wire from the distributor.
  3. Remove the spark plug wire from the wire separators.
    Fig 1: View Of Spark Plug Wire Retaining Bracket
    GM317450Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals