Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the knock sensor (2).

Fig 1: Locating Knock Sensor & Retaining Bolt
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the knock sensor bolt (1).
Tighten: Tighten the bolt to 25 N.m (18 lb ft).
Connect the knock sensor electrical connector (1).

Fig 2: View Of Ground Strap And CMP & Fuel Pump/Oil Pressure Sensor Connectors
Courtesy of GENERAL MOTORS CORP.
Install the distributor. Refer to Distributor Replacement .