LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor (HO2S) Replacement Bank 2 Sensor 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the connector position assurance (CPA) retainer.
    NOTE: Refer to HEATED OXYGEN AND OXYGEN SENSOR NOTICE in Cautions and Notices.
  3. Disconnect the HO2S electrical connector.
    Fig 1: View Of O2 Sensor Harness Routing And Harness Mounting Brackets
    GM664828Courtesy of GENERAL MOTORS CORP.
  4. Remove the bank 2 HO2S (2).
    Fig 2: Removing HO2S
    GM815044Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals