LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the bleed hose on the J 34730-1A  from the approved container. See Special Tools .
    Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
  2. Remove the shop towel from around the fitting and discard into an approved container.
  3. Disconnect the J 34730-1A  from the fuel pressure valve. See Special Tools .
  4. Install the fuel rail pressure fitting cap.
scientia non olet · About LEMON Manuals