LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the caps from the fuel feed/return, and EVAP lines.
  2. Install and connect the fuel feed (1) line to the sending unit and retaining clips.
    Fig 1: Identifying Fuel Feed Line
    GM1306291Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals