LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the caps from the EVAP purge valve and the chassis EVAP line.
  2. Install the EVAP canister purge solenoid valve line.
    Fig 1: Connecting EVAP Canister Purge Solenoid Valve Line
    GM1528274Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister purge solenoid valve line (3) to the chassis pipe.
  4. Connect the EVAP canister purge solenoid valve tube to the valve.
scientia non olet · About LEMON Manuals