LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. If necessary, connect the EVAP lines to the canister.
  2. If necessary, install the EVAP canister to the shield, perform the following:
    Fig 1: Installing EVAP Canister
    GM1228104Courtesy of GENERAL MOTORS CORP.
    1. Install the canister to the shield.
    2. Ensure the retaining clip engages on the bottom of the canister.
  3. Install the EVAP canister with shield to the bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the EVAP canister nut.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

  5. Connect the canister EVAP line to the fuel bundle line.
  6. Connect the fuel tank EVAP line to the canister.
  7. Connect the EVAP CVS line to the canister.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals