LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the purge solenoid to the intake manifold.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the purge solenoid stud.
    Fig 1: Installing Purge Solenoid
    GM1503010Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the stud to 12 N.m (106 lb in).

  3. Install the engine wiring harness bracket to the stud.
  4. Install the purge solenoid nut.

    Tighten:  Tighten the nut to 12 N.m (106 lb in).

  5. Connect the purge solenoid electrical connector (1).
    Fig 2: Connecting Purge Solenoid Electrical Connector
    GM1502053Courtesy of GENERAL MOTORS CORP.
  6. Connect the EVAP canister purge solenoid valve tube (1) to the valve (2).
    Fig 3: Connecting EVAP Canister Purge Solenoid Valve Tube
    GM1501881Courtesy of GENERAL MOTORS CORP.
  7. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals