Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the air cleaner by pressing downward until the grommets are seated.

Fig 1: Installing Air Cleaner Assembly
Courtesy of GENERAL MOTORS CORP.
Connect the MAF/IAT sensor electrical connector (4).

Fig 2: View Of Auxiliary Battery Relay, MAF, IAT & Coolant Level Sensor Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
Install the outlet resonator to the MAT/IAT sensor.

Fig 3: View Of Air Cleaner Outlet Duct Clamp
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Tighten the air cleaner outlet duct clamp at the MAF/IAT sensor.
Tighten: Tighten the clamp to 4 N.m (35 lb in).