LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the drive side knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages, and Console.
  2. Unseat the accelerator cable retainer (3) from the accelerator pedal lever (2).
    Fig 1: Disconnecting Accelerator Cable From Accelerator Pedal
    GM372959Courtesy of GENERAL MOTORS CORP.
  3. Remove the end bushing retaining clips.
  4. Remove the end bushings from the pivot shaft.
  5. Remove the accelerator pedal.
scientia non olet · About LEMON Manuals