LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Controls Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the accelerator cable through the front of dash. Snap the accelerator cable cover tangs (1) through the front of dash.
  2. Install the accelerator cable through the slot in the accelerator pedal lever.
    Fig 1: Connecting Accelerator Cable From Accelerator Pedal
    GM372959Courtesy of GENERAL MOTORS CORP.
  3. Seat the accelerator cable retainer (3) into the accelerator pedal lever (2).
  4. Install the driver side knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages, and Console.
  5. Connect the accelerator cable to the accelerator control bracket.
    Fig 2: View Of Accelerator Cable To Accelerator Control Cable Bracket
    GM781990Courtesy of GENERAL MOTORS CORP.
  6. Connect the accelerator cable to the engine bracket.
  7. Install the accelerator cable slug to the throttle body pulley.
    Fig 3: Connecting Accelerator Cable To Throttle Body Pulley
    GM781992Courtesy of GENERAL MOTORS CORP.
  8. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals