Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0125, P0335, P0336, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0464, P0496, P0500, P0502, P1106, P1107, P2610 are not set.
The diagnostic runs once with a 10 hour minimum between tests after a fail.
The start up intake air temperature (IAT) is between 4-30°C (39-86°F).
The start up engine coolant temperature (ECT) is less than 30°C (86°F).
The start up IAT and ECT are within 8°C (15°F).
The barometric pressure (BARO) is greater than 74 kPa.
The ambient air temperature is between 2-32°C (36-90°F).
The engine run time minimum is 600 seconds.
The odometer displays greater than 10 miles.
The vehicle has traveled more than 3 miles this trip.
The ECT is more than 70°C (158°F).
The fuel level is between 15-85 percent.
The ignition is OFF.
One test occurs at ignition OFF after a cold start drive cycle and may require up to 45 minutes to complete. For the controller to report a fail, several tests must be completed with at least 17 hours between each test.