Conditions For Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0128, P0171, P0172, P0174, P0175, P0200, P0230, P0300, P0449, P0461, P0462, P0463, P0464, P0496, P1111, P1112, P1114, P1115, P1121, P1122, P1380, P1381 are not set.
The Engine Run Time parameter is more than 60 seconds.
The ECT Sensor parameter is more than 60°C (140°F).
The IAT Sensor parameter is more than -10°C (+14°F).
The TP Sensor parameter is less than 0.7 percent.
The BARO parameter is more than 65 kPa.
The Vehicle Speed Sensor parameter is less than 1.6 km/h (1 mph).
The Ignition 1 Signal parameter is between 9-18 volts.
There is no additional electrical load.
The above conditions are met for more than 2 seconds.
DTC P0506 runs continuously when the above conditions are met.