Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0461, P0462, P0463, P0464, P0496, P0222, P0223, P0608, P2101, P2119, P2120, P2122, PP2123, P2125, P2127, P2128, P2135, P2138 are not set.
No fuel filling during the engine OFF natural vacuum (EONV) test period.
The fuel level is between 15-85 percent.
The barometric pressure (BARO) is more than 74 kPa.
The engine run time before engine shut-off was greater than 10 minutes.
The drive distance before engine shut-off was more than 5 kilometers (3.1 miles).
The ignition is OFF.
The ambient air temperature (AAT) at the end of the drive cycle is between 2-32°C (36-89°F).
DTC P0442 runs once per drive cycle during the hot soak period after the ignition is turned OFF, and may require up to 45 minutes to complete. The controller will not make more than 2 test attempts per day, and the time since the last complete EONV test must be at least 17 hours.