Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0030, P0036, P0050, P0053, P0054, P0056, P0059, P0060, P0101, P0102, P0103, P0106, P0107, P0108, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0151, P0152, P0153, P0154, P0155, P0157, P0158, P0160, P0161, P0200, P0300, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P0506, P0507, P1133, P1134, P1153, P1154, P2A01, P2A04 are not set.
The Fuel Trim Learn parameter is enabled.
The Loop Status parameter is closed.
The engine coolant temperature (ECT) is between -40 to +139°C (-40 to +282°F).
The intake air temperature (IAT) is between -20 to +152°C (-4 to +304°F).
The manifold absolute pressure (MAP) is between 15-105 kPa (2.2-15.2 psi).
The vehicle speed is less than 132 km/h (82 mph).
The engine speed is between 400-6,500 RPM.
The barometric pressure (BARO) is more than 70 kPa (10.7 psi).
The mass air flow (MAF) is between 1-250 g/s.
The fuel level is more than 15 percent.
This diagnostic runs continuously once the above conditions are met.