Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0128, P0169, P0178, P0179, P0200, P0220, P0442, P0446, P0452, P0453, P0455, P0496, P1125, P1258, P1516, P2101, P2108, P2135, U0107 are not set.
The Loop Status parameter is closed.
The Ignition 1 Signal parameter is between 10-18 volts.
The Fuel Alcohol content parameter is less than 90 percent.
The Fuel Tank Level Remaining parameter is greater than 10 percent.
The TP Indicated Angle parameter is between 3-70 percent more than the value observed at idle.
The above conditions are met for 2 seconds.
This diagnostic runs continuously when the above conditions are met.