LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (ENGINE CONTROLS - 6.6L - DIAGNOSIS (DTCs P0016-P0401)) >> DTC P0340, P0341 or P0342 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. With the key ON and the CMP sensor disconnected, measure the voltage between the 5-volt reference and a good ground and observe that the DMM measures 4.98-5.02 volts.
    • If the DMM does not measure 4.98-5.02 volts, test the 5-volt reference for an open, high resistance, or for a faulty ECM.
  2. With the key ON and the CMP sensor disconnected, measure the voltage between the 5-volt reference circuit and the low reference circuit and observe that the DMM measures 4.98-5.02 volts.
    • If the DMM does not measure 4.98-5.02 volts, test the low reference for an open, high resistance, or for a faulty ECM.
  3. With the key ON and the CMP sensor disconnected, connect a fused jumper wire to the signal circuit and momentarily and repeatedly probe the low reference circuit, and observe if the Cam Signal Present and Engine RPM parameters change.
    • If the cam signal and engine RPM parameters do not change, test the signal circuit for an open, high resistance, a short to ground, a short to voltage, or a faulty ECM.
  4. Ensure that the CMP sensor circuits are not routed too closely to the fuel injector wiring, after-market add-on electrical equipment, solenoids, relays, or motors.
  5. Inspect the CMP sensor for physical damage, loose or improper installation, excessive air gap, or foreign material passing between the sensor and the reluctor wheel.
  6. Inspect the CMP reluctor wheel for physical damage, improper installation, or excessive endplay or looseness.
  7. If no other condition is found, replace the CMP sensor.

scientia non olet · About LEMON Manuals