Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify the integrity of the air induction system by inspecting for the following conditions:
- Damaged components
- Loose or improper installation
- Restrictions in the MAF air induction system
- Water intrusion
- A wide open throttle (WOT) acceleration from a stop should cause the MAF sensor parameter on the scan tool to increase rapidly. This increase should be from 30-37 g/s at idle to 400 g/s or more at the time of the 2-3 shift.
- Verify that any electrical aftermarket devices are properly connected and grounded. Refer to Checking Aftermarket Accessories .