Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTC P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0642, P0643, P0652, P0698, P0699, P2228, P2229 are not set.
The ignition 1 signal is between 9-18 volts.
The intake air temperature (IAT) Sensor parameter is more than -20°C (-4°F).
The engine coolant temperature (ECT) Sensor parameter is more than -20°C (-4°F).
The BARO Sensor parameter is more than 71 kPa.
The engine speed is less than 3,500 RPM.
The engine speed is steady within a range of 50 RPM.
The above conditions are met for more than 2 seconds
This DTC runs continuously within the enabling conditions.