Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0107, P0108, P0117, P0118, P2563, P2564, P2565, P2228, P2229 are not set.
The battery voltage is equal to or greater than 11 volts.
The ECM is commanding the turbocharger vanes open or closed during a position learn process.
The engine speed is between 600-750 RPM.
The calculated fuel rate is less than 30mm³ .
The engine coolant temp (ECT) is between 163-205°F (73-96°C).
DTC P003A runs once per key cycle when the above conditions are met.