Symptoms - Engine Controls: Intermittent

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Inspect for improper installation of electrical components if an intermittent condition exists. Inspect for aftermarket theft deterrent devices, lights, and cellular phones. Verify that no aftermarket equipment is connected to the class 2 circuit. If you can not locate an intermittent condition, a cellular phone communication signal may cause the condition.

IMPORTANT: The condition may or may not turn ON the MIL or store a DTC.

Faulty electrical connections or wiring cause most intermittent conditions. Perform a careful visual and physical inspection of the suspect connectors for the following conditions:

Improperly mated connector halves
Terminals that are not seated
Terminals that are damaged or improperly formed

Reform or replace connector terminals in the affected circuit to ensure proper contact tension. Refer to Connector Repairs . Remove the terminal from the connector body in order to inspect for poor terminal wire connection. Refer to Testing for Intermittent Conditions and Poor Connections .

Road test the vehicle with the DMM connected to the suspected circuit. An abnormal reading that is observed when the symptom occurs is a good indication that there is a malfunction in the circuit being monitored.

Use a scan tool to help detect intermittent conditions. Useful features of the GM Techline scan tool include the following:

Trigger the Snapshot feature in order to capture and store engine parameters when the malfunction occurs. Review this stored information in order to see the specific running conditions that caused the malfunction.
Freeze Frame/Failure Records can also aid in locating an intermittent condition. Review and capture the information in the Freeze Frame/Failure Record associated with the intermittent DTC being diagnosed. Drive the vehicle within the conditions that were present when the DTC originally set.
Use the Plot Function on the scan tool to plot selected data parameters. Review this stored information to aid in locating an intermittent condition. Refer to the scan tool Users Guide for more information.

IMPORTANT: If the intermittent condition exists as a start and then stall, test for DTCs relating to the vehicle theft deterrent system. Test for improper installation of electrical options such as lights, cellular phones, etc.

Any of the following may cause an intermittent MIL with no stored DTC:

The ignition coils are shorted to a ground or arcing at the ignition wires or the spark plugs.
The PCM grounds are loose or dirty. Refer to Engine Controls Schematics .
The ignition control (IC) wires are routed too close to the secondary ignition wires, coils, or the generator. Ensure that all of the circuits from the PCM to the ignition coils have good connections.
There is an open diode across the A/C compressor clutch or any other open diodes.

Use the following tables when diagnosing a symptom complaint: